What the supplied product is
The current Marble Resin TDS identifies a water-white liquid unsaturated polyester resin. This is the resin product supplied by Samrat Poly Resins for the listed cultured-marble and artificial-stone contexts.
It is not a ready-made marble slab, countertop, vanity top, wash basin, wall panel or other completed stone product. That distinction matters because a raw resin data sheet and a finished component's performance record answer different buyer questions.
What the current documents describe
The TDS publishes supplied-resin form, colour, typical viscosity, gel time, curing time, density, styrene content, flash point, storage, shelf life, packaging and MOQ. It also uses broad product-positioning terms including filler compatibility, smooth flow, high-gloss finish, low shrinkage and water or chemical resistance after full cure.
These statements should be read in their documented context. They are not a published filler-loading limit, chemical-compatibility chart, UV or non-yellowing result, substrate-adhesion result, scratch or stain rating, or finished-product approval.
What remains part of the finished system
Finished appearance, gloss, shrinkage, hardness, polishability, dimensional result and service performance can depend on the complete marble or mineral-composite system. The current documents do not publish the mineral or filler type, other formulation components, processing conditions, surface system or tested final configuration.
This is why the page does not provide a recipe, filler percentage, pigment amount, catalyst instruction, cure schedule, casting method or polishing procedure. Those details are outside the published product documentation and this buyer guide's scope.
Turn the distinction into a better enquiry
If the requirement is actually quartz, engineered stone, a broad FRP laminate or a two-part epoxy casting system, say so explicitly so the correct product route can be reviewed.